Dents on your garage door panel can impact your home’s curb appeal. While a dented garage door panel may not seem like a big issue, it can turn potential home buyers off when it’s time to sell your house. Therefore, it’s important to keep your garage door in tip-top shape.
Whether you accidentally hit your garage door with a bike or have hail-sized dents caused by playful neighborhood kids, there are very easy DIY repairs that anyone can do to fix a dented garage door panel if the damage is not too extensive. The first thing you’ll need to do before you begin fixing the dents is to assess the extent of the damage. While it’s possible to repair minor garage door dents without the help of professionals, there are cases where it’s advisable to hire garage door experts.
At Bob’s Advance Garage Doors, we specialize in garage door repair in Decatur, garage door installation, garage door replacement, spring replacement, and more. As garage door professionals, we understand what goes into fixing a dented garage door panel.
Method 1: Hammer it out
This method involves tapping the dented surface with a mallet to flatten the surface. Here are the steps to follow:
Step 1: Clean up the dented surface area with warm water and detergent and let it dry.
Step 2: Hold a wood block against the dent and gently tap the section with your mallet to even the dent.
Step 3: If the dent is deep, you’ll need to use fine grit sandpaper to sand the area and even it out.
Step 4: Apply patching material, let it dry, and then sand it down to create smooth results.
Step 5: Lastly, apply primer and paint the dented surface area after the primer dries.
Method 2: Heat the Panel
This is a relatively simple and inexpensive method for fixing a dented garage door panel. You’ll need the following:
- A heat source
- Compressed air
- Aluminum foil
Step 1: Clean up the dented surface area with warm water and detergent and let it dry.
Step 2: Place aluminum foil over the dented surface.
Step 3: Using your heat source, heat the aluminum foil evenly for about one minute.
Step 4: Remove the foil and spray the dent with a can of compressed air for about one minute. The cold reaction from the compressed air against the heat should cause the dent to pop back into place.
Get Professional Garage Door Repair from Bob’s Advance Garage Doors
If you’re in need of reliable garage door repair in Decatur or garage door repair in Roswell, you can trust the experts at Bob’s Advance Garage Doors to do an exceptional job. We have a team of skilled, experienced, and well-equipped garage door experts who are willing to go above and beyond to meet your expectations. From garage door repair in Roswell to garage door installation, garage door replacement, garage door openers, and spring replacement, we do it all. Contact us today to book an appointment.